A how-to guide from Unclog.itWritten by a Red Seal plumber in British Columbia

20 to 30 minutes · Moderate · Updated November 2026

How to snake a sink drain.

A hand auger is a coiled cable in a drum. With the trap off, it goes straight into the pipe in the wall, which is where a plunger can't reach.

The right tool

For a sink you want a small drum auger: a 1/4-inch cable, about 25 feet long, with a thumbscrew that locks the cable. A toilet auger is the wrong tool. It is short, stiff and made for a toilet bowl.

Go in through the wall pipe with the trap off, not down through the sink. The cable gets past the bends that way, and you can see what comes out.

The steps

  1. The trap lowered into a bucket

    Take the trap off. Bucket under it, two slip nuts by hand. How to clean a sink trap. Clean it while it is off.

  2. The cable of a hand auger fed into the pipe that goes into the wall

    Feed the cable in by hand. Loosen the thumbscrew and push the cable into the open pipe until it stops. That is either a bend or the clog.

  3. The thumbscrew on the auger being tightened

    Lock it with a little cable showing. Leave about 15 cm (6 inches) of cable between the tool and the pipe and tighten the thumbscrew.

  4. The auger handle cranked clockwise

    Crank clockwise and push gently. Turn the handle clockwise with steady, light pressure. When the cable moves forward, loosen the thumbscrew, feed more, lock and crank again. Soft and gritty is grease. A sudden give means you are through.

  5. The cable pulled back with the clog on its end

    Bring it back, still turning. Keep turning clockwise as you pull the cable out, and wipe it with a rag as it comes. Have the bucket ready for what is on the end.

  6. The trap refitted and hot water flushing through

    Refit the trap and flush. Put the trap back, hand tight, and run hot tap water for a couple of minutes. Check the joints are dry.

Don't

  • Don't force it. A cable that is cranked hard against something solid kinks, and a kinked cable is finished.
  • Don't crank backwards to free it. Keep turning clockwise and ease it out.
  • Don't use it if drain cleaner is in the pipe. The cable flicks it back at you.

When a hand auger isn't enough

A hand auger reaches a few metres and scrapes a small hole. Most kitchen clogs are further along than that, and heavy grease closes up again behind a small cable. If you run out of cable, or it clears and blocks again within weeks, that is a job for a drain machine.

Questions

Can I snake a sink without taking the trap off?

You can try through the drain opening, but the cable has to get past the stopper or strainer and two tight bends, and it often curls up in the trap instead. Taking the trap off is quicker in the end.

The cable went in a long way and came back clean. Now what?

Either it went past a soft grease clog without catching it, or it turned up the vent instead of down the drain. Run water to test. If it is still blocked, it needs a machine with a bigger head.

Is a drill-powered snake better?

It is faster, and it is also much easier to kink the cable or wind it up inside the pipe. If you use one, run the drill slowly and stop the moment it binds.

More sink help

This page is general information, not professional advice for your situation. If you are unsure at any point, stop and call a licensed plumber. See the legal disclaimer.