A how-to guide from Unclog.itWritten by a Red Seal plumber in British Columbia

15 minutes · No tools, usually · Updated November 2026

How to clean a sink trap.

The bend under your sink comes apart by hand. Two nuts, one bucket, and you can see for yourself whether the clog is in it.

Before you start

  • If drain cleaner has gone into this sink, stop. The trap is full of it. What to do instead.
  • Bail the sink first. Whatever is in the bowl comes out of the trap when you open it.
  • Gloves on. What is in a trap is not pleasant.

The steps

  1. A bucket under the trap

    Bucket under the trap. Empty the cupboard and set a bucket right under the bend. Lay a towel around it.

  2. Two slip nuts being loosened by hand

    Loosen the two slip nuts. One is where the bend meets the pipe coming down from the sink. The other is where it meets the pipe going to the wall. Turn them to the left by hand. If one is stuck, wrap a rag around it and use pliers gently.

  3. The trap lowered into a bucket

    Lower the bend and tip it out. Water and sludge come with it. If there is a wad of grease, hair or a bottle cap in there, that was your clog.

  4. A trap being scrubbed with a bottle brush, with two washers beside it

    Scrub it and check the washers. Clean the bend with a bottle brush in a different sink or a bucket. Look at the two washers. If one is cracked, flattened or hard, replace it.

  5. The trap back on with water running through it

    Put it back and test. The bevelled side of each washer faces the joint. Tighten both nuts by hand, firmly. Fill the sink, pull the plug and watch the joints. Dry is done.

If the trap was clean

Then the blockage is past it, in the pipe that goes into the wall. Leave the trap off and run a hand auger into the wall pipe.

Stop and call a plumber if

  • A metal trap crumbles or splits when you turn the nut. Old chrome traps rot from the inside.
  • The pipe coming out of the wall is loose or turns with the nut
  • It still drips after new washers and a careful re-fit

Questions

Do I need a wrench?

Usually not. Plastic slip nuts are made to be done up by hand. A wrench on a plastic nut cracks it. On an old metal trap, use pliers with a rag and go gently.

Why is there water in the trap at all?

It is meant to be there. The water sitting in the bend is a seal that keeps sewer gas out of the house. It refills the first time you run the tap.

It drips at one nut after I put it back. What now?

Loosen it, check that the washer is the right way round and the two pipes line up straight, and tighten again by hand. A joint that is forced together crooked will always drip.

More sink help

This page is general information, not professional advice for your situation. If you are unsure at any point, stop and call a licensed plumber. See the legal disclaimer.